Operation Manual

16
ENGLISH
ZipLevel
ADDER (add):
To carry out accurate measurements indoors, the ADDER-function automa-
tically adds the height, respectively thickness of the measuring module on
the measured data.
Advice about the protective cover (only with ZipLevel Pro 35):
You need to state whether you are working with or without protective
cover (‘Boot on’/’Boot off’). Press HOLD to keep the data.
Then press CAL-key for 2 seconds and hold. Display alternately shows
‘bon’ and ‘boff’. Release at either ‘Boot on’ or ‘Boot off’. Press HOLD
again to leave this function. This choice is saved for further measuring!
Access to the ADDER-funktion:
1) Set the required point of reference with the ZERO-key.
2) Press
HOLD and move the measuring module to the required measu-
ring point (e.g. from the floor to the ceiling). You hear short bleeps.
Keep the measuring module stable on the measuring point. The bleeps
will stop when the figure is configured.
3) Now press the
MARK-key to add the height of the measuring module
or press the REC-key for 2 seconds to add the thickness of the measu-
ring module.
Press the HOLD-key to leave the function.
ENGLISH