User manual
Manual: Diode Series
page 8 / 37
8. Operation
1. Power
Make sure that your device is provided with the correct voltage. Wrong voltage could
lead to irreparable damages. Please nd the correct voltage data in the synoptical table
at the end of this manual. It must be ensured that the device is not directed to people or
inammable objects during installation. The “Emission - Laser on“ diode on the rear
side of the device begins to light up after the device has been connected to power
and the key has been switched ‚ON‘.
2. ILDA in / ILDA out
The device can be controlled via ILDA control signal. There are an ILDA-in (ILDA input)
and an ILDA-out interface on the rear side of the device. Connect the laser system to
the control interface (DAC) by using an ILDA cable. Do not connect the laser to standard
parallel port at your computer, but always use an appropriate ILDA interface (usually is
sold together with the laser control software). After that you are able to control your
laser by a showlaser software (e.g. Phoenix or Pangolin). Use the ILDA-out interface to
connect it to another device
3. Fuse
There is a fuse at the rear side of the device. If the fuse should blow, please change it by
a new 4At. If the problems recurs, please contact your dealer or the Laserworld service
department.
4. Key Switch
There is a key switch at the back of the laser system. Please connect the key with the
switch and turn it on. The laser device only runs when the key is inserted and switched
on. Prevent misuse! Unplug the key when the laser is unattended to prevent misu-
se of the system.
5. Safety Presets
This device has a preset active Scan Fail Safety.
6. Turn o
To turn o the device, turn the On/ O switch o and disconnect the power cable from
the mains.
Important Note:
Operate scanners/galvos only at appropriate speed according to the res-
pective scan angle. Too high scan speed will damage the scanning system.