Specification

______________________________________________________________________________
Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 04/28/15
TECHNICAL DATA SHEET
Latex•ite
®
Color Grade
®
Manufacturer Product#: Red: 11300, Beige: 11310, Gray: 11320
UPC#: Red: 090932113008, Beige: 090932113107, Gray: 090932113206
PHYSICAL PROPERTIES & PERFORMANCE
Appearance:
Thick Colored Liquid.
Maximum VOC:
Less than 25 g/L
Application Temperature:
55º F and rising.
Specific Gravity:
1.3-1.5
Viscosity:
5,000-10,000 cps
Weight Per Gallon:
9.2-11.6 lbs. per gallon
Color:
Red, Beige, or Gray
Consistency:
Thick liquid.
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
4.75gallons, Approximately 58 lbs.
Latex•ite
®
Color Grade
®
is our latest in driveway technology. Latex•ite
®
Color Grade
®
is an asphalt emulsion based driveway
sealer designed to beautify and protect your driveway. Latex•ite
®
Color Grade® will leave a deep color while providing strength
and flexibility with its advanced polymer system. Latex•ite
®
Color Grade
®
is a EZ Gel product making it easy to apply!
Features:
 Fiber reinforced for maximum strength
 Advanced polymer formula
 Non skid formula
 Low VOC formula
Coverage rates vary depending upon the condition of the existing blacktop. Smooth & previously sealed driveways will average
400-500 square feet per pail. Rough & unsealed surfaces will average 300-400 sq. ft. per pail. Rough / road-grade asphalts with
larger aggregate can cause lower than normal coverage rates. Two thin coats are recommended as thick coats will result in
uneven coverage, tracking, and curing problems. Second coat can be applied 24 hours after first application.
Sweep and clean off entire driveway using Latex•ite
®
CLEANER/DEGREASER. Scrub oil, gas spots, stains and rinse with
water. Apply Latex•ite
®
OIL SPOT PRIMER to any oil spots/stains using a paint brush. Allow Latexite
®
OIL SPOT PRIMER
to dry ½ hour prior to sealing over. If pavement is extremely hot, apply a fine water mist prior to sealing; brush out any
remaining puddles. You can edge the driveway with a large paint or wall paper brush by dipping brush into sealer and slowly
edging the driveway (put a tarp over any concrete areas so you don’t accidentally get sealer onto concrete). DO NOT DILUTE.
Allow all Latex•ite
®
patch and repair products to fully cure overnight before applying sealer. Newly paved surfaces must cure for
a minimum of 12 months.
APPLICATION
FEATURES
COVERAGE
SURFACE PREPARATION