MSDS

Page 3 of 4 2X CRACK FILLER
Inhalation: If overcome by mist or vapor, remove from exposure immediately; call a physician. If
breathing is stopped or irregular, start resuscitation, administer oxygen.
Skin: Remove any contaminated clothing and wash skin with soap and warm water. Vegetable
or mineral oil can remove dry material.
Ingestion: DO NOT INDUCE VOMITING even though vomiting may occur. If vomiting occurs, keep
head below hips to prevent aspiration of liquid into the lungs. Get immediate medical attention.
Stability: Stable
Hazardous Decomposition Products: N/A
Hazardous Polymerization: Will not occur.
Conditions to Avoid: High temperatures.
SARA TITLE III:
#302: No #304 CERCLA: No #313: No RCRA: No
Steps to be taken in case material is released or spilled:
Ventilate the area. Wear suitable protective clothing, gloves and eye/face protection. Contain and pick up waste
materials. Put in a sealed, approved container. Dispose of in accordance with federal, state and local
regulations.
Reportable Quantity (lb.): N/A
TPO (lb.): N/A
Regulations: WHMIS, SARA, state and province.
Hazardous Waste: None.
Respiratory Protection: Use only with adequate ventilation. If ventilation is inadequate, wear approved
respiratory equipment.
Ventilation:
Local Exhaust: Required
Mechanical (general): Required
Special: N/A
Other: N/A
Protective Gloves: Rubber gloves
Eye Protection: Wear safety glasses, goggles or face shield.
Other Protective Equipment: Wear suitable protective clothing.
Estimated LD50, MG/KG: N/A
Estimated LC50, MG/KG: N/A
Sensitization: N/A
Section VI – REACTIVITY DATA
Section VII – SPILL OR LEAK PROCEDURES
Section VIII – SAFE HANDLING AND PROTECTION INFORMATION