Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 1/26/09
TECHNICAL DATA SHEET
Latex•ite
®
OIL SPOT PRIMER
Manufacturer Product#: 41316
UPC#: 090932413160
Appearance:
White liquid
Maximum VOC:
Less than 10 g/L
Application Temperature:
55º F and rising.
Specific Gravity:
1.2
Viscosity:
n/a
Weight PerQuart:
2 lbs.
Color:
White in liquid state
Consistency:
Watery liquid.
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
2-4 hours
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
1 quart, approx. 2 lbs.
Latex•ite
®
OIL SPOT PRIMER is an important first step in preparing your driveway. Once you've thoroughly cleaned the
driveway it's time to prepare the oil and gas spots. If you don't treat them properly, the spots will bleed through your newly sealed
driveway and the stains will be back! Latex•ite
®
OIL SPOT PRIMER will seal over the oil and gas spots and will provide a strong
bond between the driveway and the new sealer.
 Prime oil and gas spots to ensure strong bond to new sealer.
 Apply with paint brush and allow to dry prior to sealing.
Sweep and clean off entire driveway using Latex•ite
®
CLEANER/DEGREASER. Scrub oil, gas spots, stains and rinse with
water. Apply Latex•ite
®
OIL SPOT PRIMER to any oil spots/stains using a paint brush. Allow Latex•ite
®
OIL SPOT PRIMER
to dry ½ hour prior to sealing over.
Latex•ite
®
OIL SPOT PRIMER works best when applied with a paintbrush. Shake the product first. Next, simply pour a thin coat
of primer over the affected area and use a brush to apply. Allow to dry thoroughly prior to using other Latex·ite products (patch /
repair or sealer).
Avoid applying when rainfall is likely within 24 hours of application time. Avoid applying when temperatures drop below 55º F.
When transporting this product, ensure that the container is secured and the lid is secure. Do not allow the container to tumble as
this may loosen the lid and allow leakage to occur. Do not transport on passenger seats or inside the passenger compartment of
any vehicle. Protective clothing and eyewear should be used during application.
PRECAUTIONS
APPLICATION
SURFACE PREPARATION
FEATURES
PHYSICAL PROPERTIES & PERFORMANCE