Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 09/28/16
TECHNICAL DATA SHEET
Latex•ite
®
10.1 OZ. CRACK REPAIR TUBE
Manufacturer Product#: 42376
UPC#: 090932423763
Appearance:
Thick Black Liquid
Maximum VOC:
Less than 25 g/l
Application Temperature:
55º F and rising.
Specific Gravity:
1.10
Viscosity:
4,000-7,000 cps
Weight Per Gallon:
N/A
Color:
Black
Consistency:
Black Mastic Asphalt
Boiling Point:
380°
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
10.1 oz. tube
Latex•ite
®
10 OZ. CRACK REPAIR TUBE is specially formulated using a combination of pure asphalts and rubber additives to
ensure maximum durability and flexibility. It is designed to fill cracks up to 1/2″ in width.
• Fills cracks and joints up to ½"
• Fills up to 32 feet with ¼" bead
• Fills asphalt cracks and expansion joints
 Low VOC Formula / Easy soap & water clean-up
Latex•ite
®
10 OZ. CRACK REPAIR TUBE is a simple and clean process. Before applying the product, it is important to
thoroughly clean out the crack and remove any loose debris. Use a screwdriver and whisk broom. Rinsing the crack and allowing
it to dry will give you the best results.
Cracks over ½” deep should be filled with solid material to 3/8” from surface before caulking. To apply, cut tip on 45° angle to
size of bead desired and puncture inner seal. Apply only to clean, dry surface. Insert tip into cracks forcing patching material
well into openings. Do not overfill. Do not use in cracks more than 1/2" wide. Allow to cure prior to sealing. Store in above
freezing temperatures. Apply when surface and air temperature are at least 55 degrees F.
Avoid applying when rainfall is likely within 24 hours of application time. Avoid applying when temperatures drop below 55º
F. Allow all repaired surfaces to cure 24 hours prior to sealing. For crack fillers you should wait 24 hours. If the crack filler is
firm you may seal over. When transporting this product, ensure that the container is secured. Do not transport on passenger seats
or inside the passenger compartment of any vehicle. Protective clothing and eyewear should be used during application.
PHYSICAL PROPERTIES & PERFORMANCE
FEATURES
SURFACE PREPARATION
APPLICATION
PRECAUTIONS