Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 11/5/08
TECHNICAL DATA SHEET
Latex•ite
®
ULTRA SHIELD™
Manufacturer Product#: 70691
UPC#: 090932706910
Appearance:
Thick brown liquid. Dries black.
Maximum VOC:
Less than 25 g/L
Application Temperature:
55º F and rising.
Specific Gravity:
1.3-1.5
Viscosity:
5,000-10,000 cps
Weight Per Gallon:
10.8-11.6 lbs. per gallon
Color:
Brown in liquid state. Dries black.
Consistency:
Thick liquid.
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
4.75gallons, Approximately 58 lbs.
Latex•ite
®
ULTRA SHIELD™ is our newest and most exciting addition to the Latex•ite
®
line of asphalt driveway sealers!
Latex•ite
®
ULTRA SHIELD™ is an asphalt emulsion based sealer designed to beautify and protect. Latex•ite
®
ULTRA
SHIELD™ is formulated with Nano-Guard technology and a new Ultra Flex Polymer system so not only will the sealer adhere to
your driveway better, it will adhere to itself better!!
Features:
 10 year warranty
 Nano-Guard technology for maximum adhesion
 Ultra Flex Polymers for maximum flexibility
 UV protection stays black/wont fade or dull
 Premium Gel formula…save time and effort
 Non skid formula
 Low VOC formula
Coverage rates vary depending upon the condition of the existing blacktop. Smooth & previously sealed driveways will average
400-500 square feet per pail. Rough & unsealed surfaces will average 300-400 sq. ft. per pail. Rough / road-grade asphalts with
larger aggregate can cause lower than normal coverage rates. Two thin coats are recommended as thick coats will result in
uneven coverage, tracking, and curing problems. Second coat can be applied 24 hours after first application.
Sweep and clean off entire driveway using Latex•ite
®
CLEANER/DEGREASER. Scrub oil, gas spots, stains and rinse with
water. Apply Latex•ite
®
OIL SPOT PRIMER to any oil spots/stains using a paint brush. Allow Latexite
®
OIL SPOT PRIMER
to dry ½ hour prior to sealing over. If pavement is extremely hot, apply a fine water mist prior to sealing; brush out any
remaining puddles. You can edge the driveway with a large paint or wall paper brush by dipping brush into sealer and slowly
edging the driveway (put a tarp over any concrete areas so you don’t accidentally get sealer onto concrete). Allow all Latex•ite
®
patch and repair products to fully cure overnight before applying sealer. Newly paved surfaces must cure for a minimum of 12
months.
SURFACE PREPARATION
COVERAGE
FEATURES
PHYSICAL PROPERTIES & PERFORMANCE