Specification

Dalton Enterprises, Inc., 131 Willow Street, Cheshire, CT 06410
Phone [phone] • Fax [phone] • www.latexite.com
Revised 3/2011
TECHNICAL DATA SHEET
Latex•ite
®
AIRPORT GRADE
®
Manufacturer Product#: 73066
UPC#: 090932730663
Appearance:
Thick brown liquid. Dries black.
Maximum VOC:
Less than 25 g/L
Application Temperature:
55º F and rising.
Specific Gravity:
1.3-1.5
Viscosity:
5,000-10,000 cps
Weight Per Gallon:
10.8-11.6 lbs. per gallon
Color:
Brown in liquid state. Dries black.
Consistency:
Thick liquid.
Boiling Point:
>212º F
Cure Time (50% relative humidity, 70º F):
24-48 hours.
Freeze ability:
Do not allow to freeze.
Container Size & Weight:
4.75gallons, Approximately 54 lbs.
Latex•ite
®
AIRPORT GRADE
®
is an asphalt emulsion based driveway sealer designed to beautify and protect your driveway.
Latex•ite
®
AIRPORT GRADE
®
is an advanced formula that contains polymer additives for strength and flexibility.
Features:
 4 year warranty
 Polymer fortified for strength and flexibility
 Fills hairline cracks
 EZ Stir, Non-Skid, Low VOC formula
Coverage rates vary depending upon the condition of the existing blacktop. Smooth & previously sealed driveways will average
400-500 square feet per pail. Rough & unsealed surfaces will average 300-400 sq. ft. per pail. Rough / road-grade asphalts with
larger aggregate can cause lower than normal coverage rates. Thin coats are recommended as thick coats will result in uneven
coverage, tracking, and curing problems. If needed, a second coat can be applied 24 hours after first application.
Sweep and clean off entire driveway using Latex•ite
®
CLEANER/DEGREASER. Scrub oil, gas spots, stains and rinse with
water. Apply Latex•ite
®
OIL SPOT PRIMER to any oil spots/stains using a paint brush. Allow Latexite
®
OIL SPOT PRIMER
to dry ½ hour prior to sealing over. If pavement is extremely hot, apply a fine water mist prior to sealing; brush out any
remaining puddles. You can edge the driveway with a large paint or wall paper brush by dipping brush into sealer and slowly
edging the driveway (put a tarp over any concrete areas so you don’t accidentally get sealer onto concrete). Allow all Latex•ite
®
patch and repair products to fully cure overnight before applying sealer. Newly paved surfaces must cure for a minimum of one
full season.
APPLICATION
SURFACE PREPARATION
COVERAGE
FEATURES
PHYSICAL PROPERTIES & PERFORMANCE