Instructions / Assembly

Mix additional pails as needed. If you have had the pails for a while you may want to (while still closed!) flip them
over the night prior to sealing as it will be much easier to mix the next morning.
Mist
(Only when the pavement is very HOT) Start at the end of the driveway farthest
from the street (start approximately 2 feet out). Apply a fine mist of water
to the pavement to lightly dampen the pavement ... leave no standing
puddles of water. Apply sealer to the dampened pavement. Re-mist
as needed.
Pour
Before you begin you can ‘edge’ the driveway as you may have brick pavers etc that you want to keep the sealer
off of. Use a wallpaper brush and cut in a 6” or so edge. When ready to seal start by pouring a ribbon of sealer
across the width of the driveway about 2 feet from the end of the garage or house in a snake-like pattern. Use our
18” Seal Right Squeegee.