MSDS

ManualsBrandsLatex-ite ManualsKitchen1 qt. Powerwash Driveway Cleaner and Degreaser

Page 1 of 4 POWER-WASH CLEANER

MATERIAL SAFETY

DATA SHEET

PRODUCT NAME: Latexite

Power-Wash Driveway Cleaner

MANUFACTURER NAME: Dalton Enterprises, Inc.

ADDRESS: 131 Willow Street Cheshire, CT 06410

EMERGENCY PHONE NUMBER: (203) 272-3221

TRADE NAMES & SYNONYMS: Soap

CHEMICAL NAME: Not applicable

EFFECTIVE DATE: 02/25/2008

DATE SUPERSEDED: 01/29/2008

COMPONENT PERCENT

Proprietary Surfactant 10% - 20%

Acrylic Copolymer 1 - 5%

Sodium Carbonate 1 - 5%

Tetrasodium EDTA Derivative 1 - 5%

Water 60 - 70%

N/A = Not available or applicable

Ingredients total weight % are below 100% only if all others unlisted are not considered hazardous by any federal

(OSHA, WHMIS, SARA), any state or province, or local Right-To-Know regulations.

APPEARANCE & ODOR: Green Color, Waterbase, No odor BOILING POINT: 212° F

VAPOR PRESSURE: N/A

SPECIFIC GRAVITY: 1.001 PHYSICAL STATE: Liquid

SOLUBILITY IN WATER: Infinite FREEZING POINT: 32° F

EVAPORATION RATE: not known % VOLATILE (by Wt.): 0%

PH: 12.5 THRESHOLD ODOR: N/A

WATER/OIL DIST. COEFFICIENT: N/A VAPOR DENSITY: N/A

WATER/OIL DIST. COEFFIECIENT: N/A VOC: Less than 10g/Liter

Sectio

n I

–

PRODUCT IDENTIFICATION

Section II

–

HAZARDOUS

/ NON

HAZARDOUS

INGREDIENTS

Section

III

–

PHYSICAL DATA

Section IV

–

FIRE AND EXPLOSION HAZAR

DATA

Driveway Cleaner

Summary of content (4 pages)

PAGE 1
Driveway Cleaner 1 0 0 B MATERIAL SAFETY DATA SHEET Section I – PRODUCT IDENTIFICATION PRODUCT NAME: Latexite® Power-Wash Driveway Cleaner MANUFACTURER NAME: Dalton Enterprises, Inc.
PAGE 2
DOT CLASSIFICATION: Not Regulated FLASH POINT: greater than 210° F AUTO IGNITION TEMP.: N/A LOWER EXPLOSIVE LIMIT (LEL): N/A UPPER EXPLOSIVE LIMIT (UEL): N/A EXTINGUISHING MEDIA: Water/fog/foam/dry chemical/extinguishing media may be used to neutralize burning dry material. SPECIAL FIRE FIGHTING PROCEDURES: Firefighters should wear self-contained breathing equipment. Do not allow run off from fire fighting procedures to enter public waterways.
PAGE 3
Section VI – REACTIVITY DATA STABILITY: Stable, Prevent freezing of material CONDITIONS TO AVOID: Keep from freezing, high temperatures. INCOMPATIBILITY: Material must be kept out of contact with strong oxidizing agents such as peroxides, liquid chlorine, sodium and calcium halpohalites, and other oxidizers. HAZARDOUS POLYMERIZATION: Will Not Occur HAZARDOUS DECOMPOSITION PRODUCTS: N/A CONDITIONS TO AVOID: High temperatures. Keep product from freezing. Section VII – SPILL OR LEAK PROCEDURES 1. 2. 3. 4.
PAGE 4
Do not take internally, can be harmful or fatal if swallowed. Do not store above 120° F. THE INFORMATION AND RECOMMENDATIONS PROVIDED HEREIN ARE BELIEVED TO BE ACCURATE AS OF THE DATE HEREOF. HOWEVER, SUCH INFORMATION AND RECOMMENDATIONS ARE PROVIDED WITHOUT WARRANTY OF ANY KIND AND THIS CORPORATION DISCLAIMS ANY AND ALL LIABILITY OR LEGAL RESPONSIBILITY FOR USE OR RELIANCE UPON SAME.