Use and Care Manual

PAYCLOCK & PC600 USER’S GUIDE
7
Install the PC600
Step 1: Select a site to install your PC600 terminal that will be
convenient to employees clocking in and out. When deciding where
the terminal will be installed, keep in mind that an 115vAC power
outlet should be within 6 feet of the mounting location as well as a
connection to the network (LAN).
Note: It is recommended to install and mount the PC600 terminal
before installing the PayClock software. With the PC600 terminal
powered up and connected to the network (LAN), the software will
search for it on the network and automatically configure the terminal.
Step 2: After selecting the appropriate installation site, use masking
tape to hold the included Mounting Template onto the wall. Drill
holes using the template as a guide. Note: the bottom of the terminal
should be about 45 inches from the floor.
Remove the Template from the wall and install the included
mounting screws. Install three screws, leaving approximately 3/16
inch of the screws exposed. Do not tighten all the way. Retain the
fourth screw for later.
Note: For sheetrock walls, drill a 3/16” diameter hole through each
of the four screw locations; each approximately 1-1/2” deep. Install
the plastic “anchors” included in the mounting screw packet.