Use and Care Manual

PAYCLOCK & PC600 USER’S GUIDE
14
• When finished, press the center of the screen and then press
the back 2 button until you have returned to the default
screen.
Network Setup - Terminal Settings
This menu allows you to manually configure the network
communication settings between the PC600 and PayClock software.
Note: Typically these settings are determined during the installation
of the PayClock software and it isn’t necessary to modify the settings.
To enter into administrator mode at the PC600, press the Admin
button, the Enter PIN screen will display.
• Using the numeric key pad enter the administrator PIN
number and press Enter.
• The Administrator Main Menu screen will display.
• Press Network Settings. The Network Setup screen will
display.
• If you want to set the terminal’s IP address as a “Static” IP
turn off DHCP by pressing the OFF button. The screen will
refresh and more buttons will become active.
• Press the IP Address button. The IP Address screen will
display.
• Using the numeric key pad, enter the IP address you want to
assign to the terminal and press OK.
• Press the Subnet Mask button. The Subnet Mask screen will
display.
• Using the numeric key pad, enter the address you want to
assign to the terminal and press OK.
• Press the Gateway button. The Default Gateway screen will
display.