Use and Care Manual

PAYCLOCK & PC600 USER’S GUIDE

Appendix A - PC600 WAN Installation

These instructions identify the steps to configure the PC600 terminal

to communicate with the PayClock database server across the

internet.

A print out of the “Server Summary” information is required for this

set up. If the information was not printed during the PayClock

software installation follow these steps to access the information.

• At the computer where the PayClock database server resides,

open the PayClock software.

• Click the PayClock orb on the upper left and from the menu,

select Support Assistant.

• In the Support Assistant window select

Connection Info

• Print the Connection_Info.txt file for use when configuring

the PC600.

WAN Installation Requirements

• There must be a VPN tunnel connecting the local and remote

sites.

• A static IP address is required on the computer designated as

the PayClock database server.

• A network administrator may be required to configure the

network routers to route the ports used by the PC600

terminals and PayClock database server.

Important Port Information - The following ports are used for this

type of installation.

• 7350 - PayClock Network Terminal Service

• 7351 - Auto Poll Service

• 2638 - PayClock Database Server