Use and Care Manual

PAYCLOCK & PC600 USER’S GUIDE

Appendix D - Connecting the PC600

Directly to the Computer’s NIC

This document describes the steps to configure a PC600 terminal to

communicate with the PayClock database server when connecting

directly into the computer’s wired NIC. This would be used when the

user doesn’t have a network setup and has a computer that has a

wired NIC.

Step #1 - At the Computer where PayClock is installed

See the More Information section for Windows XP, Vista and

Windows 7 directions for accessing the NIC properties.

• Open the Properties of the NIC.

• Open the Properties of the Internet Protocol item.

• Define the IP (10.0.1.1) and Subnet Mask (255.0.0.0).

Step #2 - Connect the Ethernet cable to the computer and

PC600

• The computer will go through the process of acquiring the IP

connection.

Step #3 - At the PC600 terminal

• Access the Administrator Main Menu.

• Press the Network Setup button.

• Set the DHCP to Off.

• Enter the IP address (using the computer’s IP as reference,

i.e. 10.0.1.2).

• Enter the Subnet Mask (same as what was entered at the pc,

i.e. 255.0.0.0).

• Leave the Gateway at the default (0.0.0.0).

• Press the Define Host button.