User's Guide

Mount bracket
Secure PCPROX
PCPROX Home Screen Functions
Connect cables
Plug in power
Hang PCPROX
Connect network
Mount bracket to wall
Secure PCPROX with
locking screw
The clock Admin passcode is 99999. This can be
changed in the clock’s Advanced tab in PayClock.com.
Connect cables as needed
to back of PCPROX
Plug in power adapter to wall
outlet and connect Ethernet
cable if applicable.
Hang PCPROX on wall bracket
Follow welcome instructions
on PCPROX screen to
connect to network
45in.
Mount bracket 45”
from the oor, close
to AC power and
ethernet source if
applicable.
Do not use
with POE
NO
ETHE RNE T 12V/DC USB USB
COM NC
View Total
Hours
Enter Tips or
Amounts
Supervisor
Menu
Clock In/Out
with PIN
Transfer
Departments
Admin Settings
Menu
USG0122B
4 5 6
7 8 9
For help, call [phone]
Monday – Friday, 8a – 7p Eastern Time
www.lathem.com/support
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Any changes or modications not
expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --
Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed
and operated with minimum distance between 20cm the radiator your body.
This transmitter is restricted to indoor use in the 5150MHz to 5250MHz frequency range.