Instruction Manual

©
2022 LATICRETE Australia Pty Ltd
|
www.laticrete.com.au
|
All trademarks shown are the intellectual properties of their respective owners.
Data Sheets are subject to change without notice. For latest revision, visit www.laticrete.com.au
DS-1278-0522
3
Mixing with PERMACOLOR
®
Select Colour Kits (257 TITANIUM White
only)
Requires 2 PERMACOLOR
®
Select Colour Kits. (Each Colour Kit contains 2 individual
colour packets, use all 4 colour packets) Place water in a clean mixing container.
Remove colour packets from the cardboard container as well as the protective plastic
sleeve. The internal bag is a water dispersible packet – when using the 11 kg bag of
257 TITANIUM, drop all colour packs directly in to water in clean mixing container. Mix
with a drill mixer until pigment is dispersed evenly in container and the dispersible
packet is no longer visible. Add 257 TITANIUM and mix as directed above. Please note
that additional water may be necessary when using PERMACOLOR Select colour Kits.
Application
Apply adhesive to the substrate with the flat side of the trowel, pressing firmly to work
into surface. Comb on additional adhesive with the notched side.
Note: Use proper sized notched trowel to ensure full bedding of the tile. Spread as
much adhesive as can be covered with tile in 15–20 minutes. Back notch trowel large
tile and panels to provide full bedding and firm support. Place tiles into wet, sticky
adhesive and beat in using a and rubber mallet and/or slide the tile back and forth to
embed tile and adjust level. Check adhesive for complete coverage by periodically
removing a tile and inspecting bedding adhesive transfer onto back of tile. If adhesive
is skinned over (not sticky), remove and replace with fresh adhesive.
Grouting
Grout installation after a minimum of 24 hours curing time at 21°C. Grout with
SPECTRALOCK
®†
PRO Premium Grout; PERMACOLOR Select Grout; PERMACOLOR
NS; or, PERMACOLOR Grout.
Note: Large panel and tiles will require longer time to set on non-porous surfaces
and in colder site conditions.
Cleaning
Clean tools and tile work with water while adhesive is fresh.
AVAILABILITY AND COST
Availability
LATICRETE
®
and LATAPOXY
®
materials are available worldwide.
For Distributor information:
Toll Free: 1800 331 012
Telephone: [phone]
For online distributor information, visit LATICRETE at www.laticrete.com.au
Cost
Contact a LATICRETE Distributor in your area.
MAINTENANCE
LATICRETE and LATAPOXY grouts, sealers and sealants require routine maintenance
and cleaning with a neutral pH detergent and water. See TDS 1113 for more
information.
All other LATICRETE and LATAPOXY non-finish materials require no maintenance but
installation performance and durability may depend on properly maintaining
products supplied by other manufacturers.
TECHNICAL SERVICES
Technical assistance
Information is available by calling:
Toll Free: 1800 331 012
Telephone: [phone]
Fax: [phone]
Technical and safety literature
To acquire technical and safety literature, please visit our website at
www.laticrete.com.au
DISCLAIMER
§
The information contained in this document is given in good faith and to the best
of our knowledge is true and accurate.
§ This information is subject to change without notice and it is the responsibility of
the user to obtain up to date and current information.
§ The use of this product is beyond our control and liability is assumed by the user
when used incorrectly and not in accordance with LATICRETE
®
guidelines.
§ The manufacturer is not responsible for any loss or damage arising from incorrect
usage of this product.
§ The specifier or other party responsible for the project must ensure that the details
in this data sheet are appropriate for the intended application and that additional
detailing is performed for specific design or any areas that fall outside the scope of
this specification.
§ Efflorescence is a normal condition of Portland cement and is not covered by any
warranty. The use of LATAPOXY
®
310 Stone Adhesive, LATAPOXY 300 Adhesive,
SPECTRALOCK
®
PRO Premium Grout
†
and SPECTRALOCK 2000 IG will not contribute
to any noticeable efflorescence.
†
United States Patent No.: 6,881,768 (and other Patents).
LATICRETE Australia Pty Ltd
29 Telford Street , Virginia
QLD 4014 Australia
1800 331 012
www.laticrete.com.au