Owner Manual
Owner’s Manual
LED Indoor Lighting Fixture
Installation Instructions
WARRANTY INFORMATION
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a
qualified electrician.
3. Do not use in wet locations, use indoors only.
4. Non-replaceable LEDs.
5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to
avoid eye damage.
6. Not to be used with a dimming circuit or any other electronically controlled switch.
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any packing
materials.
INSTALLATION STEPS
1. Place fixture pan (2) flush against ceiling at desired outlet box (1) location. Using outside fixture pan
holes (16) as a guide, mark where pilot holes are to be drilled.
2.
Drill 4 - 1/8 inch holes at each pencil mark then insert wall anchors (14) by gently tapping with a hammer.
3. Pull the supply wires (4 & 5) and house ground wire (6) out from the outlet box (1).
4. Connect the fixture ground wire (11) to the house ground wire (4) together using wire nut (7).
5. Wrap all wire connections with electrical tape to ensure secure connection.
6. Electrical connections. Connect the black fixture wire (10) to the black supply wire (5), and the white
fixture wire (9) to the white supply wire (6) using wire nut (7). Wrap all wire connections with electrical
tape to ensure secure connection.
CLEANING AND CARE
To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can discolor
the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.
NOTE FOR FIXTURES THAT ARE SOLID BRASS:
Your hand-crafted, solid brass lighting fixture has been coated with a durable, baked-on acrylic lacquer
which gives maximum protection against the weather. However, in time the brightness of the brass will
tarnish, giving way to an authentic old-world brass finish. To keep your solid brass fixture looking new for
years to come, regularly apply a good quality, non-abrasive car wax to all metal surfaces, giving the fixture
an extra protective covering.
Made in China
1
4
2
3
14
7
5
6
9
10
11
16
8
15
12
13
1. OUTLET BOX (EXCLUDED)
2. FIXTURE PAN
3. LENS
4. WHITE SUPPLY WIRE
5. BLACK SUPPLY WIRE
6. HOUSE GROUND WIRE
7. WIRE NUTS
8. FIXTURE SCREW
9. WHITE FIXTURE WIRE
10. BLACK FIXTURE WIRE
11. FIXTURE GROUND WIRE
12. RING
13. CAP NUTS
14. WALL ANCHOR 4PCS
15. ANCHOR SCREW 4PCS
16. OUTSIDE FIXTURE PAN HOLES
7. Thread the fixture screws (8) into the appropriate threaded holes of the outlet box (1).
8. Carefully tuck all wires back into the outlet box. Place the fixture pan (2) over outlet box and feed
fixture screws (8) through the fixture pan's keyhole slots. Rotate the fixture pan (2) clockwise until
screws (8) slide into the narrow end of the keyhole slots and tighten firmly.
NOTE: For added support, anchor screws (15) may also be mounted in additional support holes.
9. Final assembly - Secure the lens (3) and ring (12) to fixture pan (2) using for cap nuts (13).
10.
Installation complete, restore power at the circuit breaker and turn light switch on to activate this fixture.
Congratulations on your purchase. This fixture has been designed to give you many years of beauty and
service.