Installation & Assembly

Assembly
and Insiallation
Instruction
Warning!!! Shut
Porver
OffAt
Fuse or Circuit
Breaker .
1.
Carefrrlly
unpack
your
new fixture
and lay out
all
the
parts
on clear area.
Take care not to loose
any small
parts
necessary for installation.
2. Hold
Back Piate up against the
wall
aligning the
two
holes in the Outlet
Box with appropriate
holes
in the Back Plate, Then
u'hiie
the
Back
Plate is leveled
horizontally,
use a
pen
or
pencil
to
make a mark on the
rl'all
at holes located near
each end of
Back Plate.
Set aside the
Back Plate
and insert
Plastic Anchors into the four marks made
on
the
wall.
3. Thread the
supply
wires and
ground
wire from
Outlet Box
tfuough ce:rter
hoies in
Back P1ate.
1.
Attached the Back
Plate to Outlet box b1' using the two Outlet
box Screws.
if Plastic Anchors
were
attached
to the
lvall.
secure
the Back Plate with four Anchors Screws
to corresponding holes.
5. Connect the fixture wires to
the
Outlet
Box
u'ires
as
follows. Connect the
White Fixture wire
to the White Supply Wire,
Connect the Black Fixture Wire to the Black
Supply Wire. Make sure
all wire
Connectors are secure
and do not easil,v
pull
offwith
the slight tug.
If there is no
Green
Ground
Wire
from the Outlet Box, Connect
the
Fixture Ground
Wire to the Cross
Bar u'ith
the
Green Grounding Screw
provided.
6. Once ail wires are connected, tuck them
carefullf
into Outlet Box.
7. Place the
Fixfure
Front Plate
over
the
Mounting Screu's. so it
protrude
through
the hole in the
Back
Plate.
8. Thread the Finial
onto the
Mounting
Screws and continue tuming until the Front Plate is snug
against
Back
Plate.
9. Slide
Glass Shade and Spacer
onto Socket, and use Socket
Wrench
to secure Glass Shade b1'threading
Socket
fung
over Socket.
Thread
Bulb to Socket.
(Bulb
not included)
10.
Return
the
power
to the Outlet Box
and test fixture. Your installation is
now
complete.
Supply
ourlet Box
wh
I
h--
r*c
Anchor
[]
'**r***=,-l!,l
Mounting
Sqew