Installation & Assembly

D — F in ia l(I)
ASSEMBLY INSTRUCTIONS:
VERY IMPORTANT
PLEASE READ THOROUGHLY. MAKE SURE YOU PROPERLY ALIGN POLES BEFORE
SCREWING THEM TOGETHER TO AVOID DAMAGING CONNECTION THREADS.NOT
ADHERING TO THIS PROCEDURE MAY VOID YOUR WARRANTY.
1. CAREFULLY UNPACK AND PLACE ALL PARTS ON A FLAT SURFACE AND LINE THEM
UP AS PER THE SKETCH
2. SCREW TUBE (B), GLASS PANEL (C), TUBE (D) AND SOCKET SECTION (E) INTO BASE (A)
IN TURN, PULL THE WIRE OUT FROM BOTTOM OF THE BASE (A).
3. INSERT HARP (G) INTO SADDLE OF SOCKET SECTION (E).
4. INSERT BULB (F) INTO SOCKET.
5. PLACE SHADE (H) ONTO HARP (G), SECURE WITH FINIAL (I) AND ADJUST SHADE (H).
6. INSERT THE POLARIZED PLUG INTO WALL OUTLET, TURN ON THE SWITCH AND ENJOY
YOUR NEW LAMP
USE A 23W CFL TYPE BULB OR 100W (MAXIMUM) INCANDESCENT A TYPE BULB.
— S o ck et se ctio n (E )
IMPORTANT SAFETY INSTRUCTIONS:
This portable lamp has a polarized plug (one blade is wider than the other) as safety a feature to
reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.
ATTENTION: POUR PRÉVENIR LES CHOCS ÉLECTRIQUES NE PAS UTILISER CETTE
FICHE POLARISÉE AVEC UN PROLONGATEUR, UNE PRISE DE COURANT OU UNE AUTRE
SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ÊTRE INSÉRÉES A FOND SANS EN
LAISSER AUCUNE PARTIE À DÉCOUVERT.
-Tube(D )
j Glass P a n e l(C)
^ PLEASE INFORM YOUR DEALER IMMEDIATELY IN CASE OF ANY PARTS SHORTAGE.
^ SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.