Installation & Assembly

1 | Page Installation Instructions for Wall Panels

1 Select the location of the first

panel and level it

2 Place the template and mark

the location with the use of

screws.

3 Drill the holes for anchor

placement (1/4 mesh)

4 Place the anchors in the

hole

5 Hammer the anchor into the wall to

make it flush

6 Drill in the screw leaving 1/2 of

inch

7 Place the template to make

the proper adjustments

8 Tighten the screws so

that the template is

pressed against the wall

but has enough space to

move up and down

9 Lift the template and

remove

10 You may now place your first panel

PAGE 1
|Page Installation Instructions for Wall Panels 3 Drill the holes for anchor placement (1/4 mesh) 1 Select the location of the first panel and level it 2 Place the template and mark 4 Place the anchors in the the location with the use of screws.
PAGE 2
|Page Installation Instructions for Wall Panels 11 Place the template on top of the installed panel and mark the position 12 Once the second position has been marked, drill 1/4 of inch for anchor placement, insert the anchors, drill in the screws and install the template. You may refer to step #8 16 Remove the template 17 Install the leather panel 13 Remove the template and install your second leather panel. You may repeat these steps as needed.