Assembly Instructions

Put Seat Cushion(K) and Back Cushion(L) on the Loveseat.
Your Loveseat is ready for use.
This Loveseat can only be used on a flat, level surface.
Step 5
Place the Loveseat on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully sit onto the Loveseat.
This will help to align all parts at all joints.Then get off the Loveseat, and in a sequential manner,
proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Step 4
Attach Backrest(J) to Right Armrest(G) and Left Armrest(H) using Bolts(①) and Washers(③) with
Allen Key(④) as shown above.
Attach Backrest(J) to Seat(I) using Bolt(②) and Washer(③) with Allen Key(④) as pictured.
Do not fully tighten the Bolts.
Step 3
Back Cushion(L)
Seat Cushion(K)
Page 4 OF 5