Assembly Instructions

Attach Leg(N) to Table Top Frame(O) using Bolts(⑤) and Washers(③) with Allen Key(④)
as shown above.
Do not fully tighten the Bolts.
Place the Table on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully push down onto the Table with your hands.
This will help to align all parts at all joints.Then get off the Table, and in a sequential
manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This may cause the frame to warp.
If there are still wobbles, loosen the Bolts and execute this same process.
Note: This step is done best with the assistance of a second adult.
Carefully place the Glass Top(M) onto the assembled Table.
Caution: The Table and its Parts are Heavy. Two adults are required for lifting and
moving them.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Step 2
Step 3
Step 4
Glass Top(M)
Page 3 OF 4