Caution : You should read this before proceeding Please look in the velcro pouch for hardware packs and legs LIFT TOP COFFEE TABLE Label A Picture Description Table Top B Table Base C Table Leg QTY 1 1 4 Page 1 OF 6
Label ① ② ③ ④ ⑤ ⑥ Picture Description Long Bolt (M6*62MM) Spring Washer (M6) Flat Washer (M6x19mm) Allen Key (M6mm) Short Bolt (M6*16mm) Angle iron (25*25*1.
Overview This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is provided to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Please place the product on a platform. Lift up on the top of the Coffee Table to open, then take out the inner carton.
Step 2 Find A flat case to hold A, then pull the lift panel open. Attach Table Legs(C) to Table Top(A) using Bolts(①), Spring Washers(②), Washers(③) and the Allen Key(④). Do not fully tighten the Bolts at this time. Step 3 Place the Table Top(A) facedown onto a clean, non-marring surface.A helper should help hold B. 3.1) With the help of another adult ，attach the Table Legs(C) to the Table Base(B) using Bolts(⑤), Spring Washers(②),Washers(③),the Angle iron(⑥)and the Allen Key(④).
Step 4 CAUTION 1: When tightening these screws, tighten sequentially. If there arte any wobbles after tightening, loosen the screws and execute this same process. Ensure all screws are fully locked into position. Your Table is ready for use. This Table can only be used on a flat, level surface.
