READ AND SAVE THESE INSTRUCTIONS 60” Damp Location Ceiling Fan Owner's Manual Net Weight: 16.7 Lbs.
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3.
This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Tools Needed for Assembly Installed Wire Length Up to 50 ft. 50-100 ft. One Phillips head screwdriver One stepladder One wire stripper WARNING ! MATERIALS Wire Size A.W.G. 14 12 Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 6).
2. Remove the two setscrews from the top of the motor coupler (Figure 1). Retain the setscrews for future use. Electrical Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. 3. Route the two 80” motor leads through the center hole in the motor cover. Place the motor cover over the motor by aligning the reversing switch hole in the cover over the reversing switch as shown in Figure 2.
! PIN WARNING SETSCREW It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 4) could result in the fan falling.
! How To Wire Your Ceiling Fan and Install the Control WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall. If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
3. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 11). 9. Slide the Fan Control to the OFF position (0). 10. Connect one BLACK wire from the Fan Control to the fan/motor lead with a wire connector (provided). (Figure 13.) 4. Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 11). TO NEUTRAL 5.
4. The fan blades will turn in the opposite direction and reverse the airflow. Using Your Ceiling Fan Season Summer Winter 4 Reverse Switch Information Rotation Direction Switch Position Counter-Clockwise Down Clockwise Up 3 2 1 0 REVERSIBLE SWITCH Figure 15 IMPORTANT Fan installation must be completed, including the installation of the fan blades, before testing of the controls. Figure 16 1. Restore electrical power to the outlet box by turning the electricity on at the main fuse box. 2.
Energy Efficient Use of Ceiling Fans Ceiling fan performance and energy savings rely heavily on the proper installation and use of the ceiling fan. Here are a few tips to ensure quality and product performance. comfortable breeze, lower speeds consume less energy. In the winter, reverse the motor and operate the ceiling fan at low speed in the clockwise direction. This produces a gentle updraft, which forces warm air near the ceiling down into the occupied space.
Repair Parts 3 1 2 9 4 4 3 20 2 1 0 15 14 8 7 16 13 12 17 10 11 6 5 19 18 10
Repair Parts Listing Part Numbers Key Description No.
LIMITED WARRANTY
