Installation & Assembly

ManualsBrandsLatitude Run ManualsArmoires & WardrobesDankmar Home Bedroom Utility Armoire

Table Of Contents

ASSEMBLY INSTRUCTION

PLEASE READ BEFORE ASSEMBLING!

 





 



 

PAGE 1 OF 11

Summary of content (11 pages)

PAGE 1
ASSEMBLY INSTRUCTION PLEASE READ BEFORE ASSEMBLING! Tip #1: Make sure you've taken all the pieces and hardware out of its packaging before discarding the box. Assembly on top of flattened box/ blanket is recommended. Tip #2: Using page 2 and/or page 3 of instruction manual make sure all pieces and hardware are accounted for. Tip #3: Note position of all holeson each panel during assembly.
PAGE 2
PARTS IDENTIFICATION (1) (2) (3) (4) (5) (6) (7) 2pcs 2pcs 2pcs 2pcs 2pcs 2pcs lpc (8) (9) (10) (11) (12) (13) (14) lpc lpc lpc lpc 2pcs 2pcs lpc (15) (16) (17) (18) (19) lpc lpc 2pcs lpc lpc x2 PAGE 2 OF 11
PAGE 3
PAGE 4
ASSEMBLY INSTRUCTION STEPl STEP2 x2 STEP3 x2 Dx8 Ex4 PAGE 4 OF 11
PAGE 5
ASSEMBLY INSTRUCTION STEP4 STEP5 Ax2 Bx2 PAGE 5 OF 11
PAGE 6
ASSEMBLY INSTRUCTION STEP6 STEP7 14 Bx4 PAGE 6 OF 11
PAGE 7
ASSEMBLY INSTRUCTION 11 STEPS STEP9 15 PAGE 7 OF 11
PAGE 8
ASSEMBLY INSTRUCTION '- "=:-----------t 16 � Bx 4 Nx4 15 STEPlO STEPll 17 ' ' ' ' Lx40 15 PAGE 8 OF 11
PAGE 9
ASSEMBLY INSTRUCTION Gx2 Hx4 14 STEP12 STEP13 Mxl Kx2 14 PAGE 9 OF 11
PAGE 10
ASSEMBLY INSTRUCTION STEP14 � Hx 24 To adjust the door in or out,loosen this screw and push the door further in or push further out then retighten screws. 18 15 To adjust the door vertically, loosen the top and bottom screws, push the door up or down as necessary, then retighten screws. To adjust the door left/right, turn this screw clockwise to move this corner of the door toward the frame, or counterclockwise to move door away from the frame.
PAGE 11
ANTI-TIPPING STRAP INSTRUCTION TOOLS NEEDED ( NOT INCLUDED): HARDWARE(INCLUDED): DRYWALL ANCHOR ¢8X40 X lPC � METAL BRACKETS 12 X 12 X 1 X 2PCS 0llll1111))111111111> DRILL & DRILL BIT LIGHT HAMMER DRYWALL SCREW ¢5X40 X lPC STRAP 197 X 5 X 1 X lPC FLATHEAD SCREW ¢4X25 X lPC Note: Hardware included only compatible with standard drywalls. STEP 1 1.Find spot on wall 1" below top of item. 2.Using a drill bit slightly thinner than anchor ,drill hole into drywall. 1.