Caution : You must read this before you proceed.
Part NO.
Before Beginning Assembly: Unpack and place all parts for clear visibility Pack A for assembling the 'H' Leg Frame (B) to the Chair Seat (A) 9pcs of 50mm Bolts + 9pcs of Flat Washer Ring + 9pcs of Spring Washer + one Allen Key Pack B for assembling the 5pcs Ø4*38mm Side Rails (C) to Screws the 'H' Leg Frame (B) Page 3 OF 6
Step 1 A. Seat B. 'H' Leg Frame C. Side Rails Place the Barstool Seat (A) onto a soft surface to avoid any scratches or damages to the product. REMOVE the Seat Base Cover from the underside of the Seat (A), take out the Side Rails (C) and hardware. Step 2 Insert the Side Rail (C) into the oval housing of 'H' leg frame (B) as shown above. Then, use the hardware of Part B to attach the Side Rails (C) to the other 'H' Leg frame (B). WARNING !! DO NOT OVER TIGHTEN.
Step 4 Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps, to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the bolts.
Page 6 OF 6
