Owner Manual

ManualsBrandsLatitude Run ManualsBathroom MirrorsWall Mounted Frameless Medicine Cabinet with 3 Adjustable Shelves and LED Lighting

































 



the

The

the

Summary of content (12 pages)

PAGE 1
the The
PAGE 2
PAGE 3
LED CABINET INSTALLATION GUIDE IMPORTANT SAFETY INSTRUCTIONS When using an electrical furnishing, basic precautions should always be followed, including the following DANGER READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS MIRROR WARNING To reduce the risk of burns, fire, electric shock or injury to persons. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop o insert any object into any opening.
PAGE 4
LED CABINET INSTALLATION GUIDE TOOLS REQUIRED FOR ASSEMBLY Electrical Drill Phillips Screwdriver 1/8” Drill Bit Pencil Tape Measure Level PARTS INCLUDED SCREW (x7) WALL PLUG (x7) (x3) (x12) (x8) (x2) (x1) (x2) (x6) NOTE: Determine overall mirror dimensions before proceeding to installation. *All dimensions & specifications are approximate and subject to change without notice.
PAGE 5
LED CABINET INSTALLATION GUIDE ELECTRIC CONNECTIONS ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN WARNING: Shut off power before wiring the mirror. WARNING: An Electrical option mirror must be wired to a 20 Amp GFl (Ground Fault Interrupter) protected circuit when used in bathrooms and all other locations required by the National Electric Code.
PAGE 6
WALL HUNG INSTALLATION PLACEMENT Select the desired position of the cabinet. Level and mark the location. SUPPORT LOCATION Measure the center of the holes and mark the drilling locations ensure marking are leveled. A A 3" B A INSTALL SCREWS screw and the wall. A B C Using the two provided screws, install the bracket onto the bottom of the cabinet.
PAGE 7
WALL HUNG INSTALLATION Hang the cabinet on the cleats and check level, adjust horizontally to desired location. (This may require two people) Lift and remove the cabinet from the wall to reveal the pencil mark location of the bracket. Mark the location of the bottom bracket on the wall with a pencil. Uninstall the bracket from the mirror by removing the two screws previously installed during step 4.
PAGE 8
WALL HUNG INSTALLATION Using the screw provided, mount the bracket to the wall at the marked pencil location. Do not over-tighten Using screws provided, align lower bracket and attach to cabinet. Lift cabinet and carefully lower onto cleats and adjust horizontally. Install side mirror.
PAGE 9
WALL HUNG INSTALLATION Install clamps to hold the glass shelf, and install the shelf. Secure the position of the glass shelf. 3 1 2 1.Move door away/towards the cabinet. This must be adjusted first to prevent scratching the surface of the aluminum cabinet. 2.Move door(s) up/down 3.
PAGE 10
RECESS INSTALLATION Measure the size of the cabinet mouted inside the wall. Draw the dimension of the cabinet on the wall. A B B 3.8” mininum A Dig out the mounting holes for installation of the mirror cabinet. Frame the opening for the cabinet based on the measurements. Cut the marked dimension with suitable tool. Connect electrical wires before inserting the cabinet into the opening.
PAGE 11
RECESS INSTALLATION Position cabinet in cut out opening. Affix using hardware screws into the studs. Be careful to avoid squeezing the wiring while insert the cabinet. Install clamps to hold the glass shelf, and install the shelf. Secure the position of the glass shelf. 3 1 2 1.Move door away/towards the cabinet. This must be adjusted first to prevent scratching the surface of the aluminum cabinet. 2.Move door(s) up/down 3.
PAGE 12
FINAL ASSEMBLY Single button touch switch Touch to turn the task light and defogger on or off. Press and hold to change the color temperature of the task light.