User's Manual

CARE
MAINTENANCE
This heart rate sensor is a high-tech instrument that should be handled with care.
Follow the caring instructions to ensure reliable measurement and to maximize
the life span of the heart rate sensor. It is advisable to use the unit and the chest
strap in conformity with the following instructions:
Connector: Detach the connector from the strap after every use and dry it with a
soft towel. Clean the connector with a mild soap and water solution
when needed. Never use alcohol or any abrasive material such as
steel wool or cleaning chemicals.
Strap: Rinse the strap under running water after every use and hang to dry. Clean
the strap gently with a mild soap and water solution when needed. Do not
use moisturising soaps as they can leave reside on the strap. Do not soak,
iron, dry clean or bleach the strap. Do not stretch the strap or bend the
electrode areas sharply.
Dry and store the strap and the connector separately to maximize the heart rate
sensor battery lifetime. Keep the heart rate sensor in a cool and dry place. Do not
store the heart rate sensor wet in non-breathing material, such as a sports bag,
to prevent snap oxidation. Do not expose the heart rate sensor to direct sunlight
for extended periods.
Remove the battery from the battery case when the unit or the chest strap WILL
NOT be used for a long time.
A. Introduction: A-04
WARNING!
A. Introduction: A-02
Make sure that fully understand the functions and limitations of
this product before using it.
Consult a doctor or trainer for setting the zone prior to undergo
an serious Cardio-fitness training.
This product is an supplementary device for heart rate
measurement, and it is NOT a substitute for getting the heart
rate reading from a doctor.
If the heart rate condition is in doubt, consult your doctor.
Avoid exposing the product to the extreme conditions.
Avoid rough uses or severe impacts to the product.
FCC Compliance Statement
A. Introduction: A-03
- This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesirable operation.
- WARNING: Changes or modifications to this watch not expressly approved by
the party responsible for compliance could void the user’s right to operate the
equipment.
- NOTE: This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and radiates radio
frequency energy. If it is not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications.
- However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
recommended to reduce the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation space between the watch and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
(For US)
A. Introduction: A-01
Thank you for purchasing this Bluetooth Chest Belt Heart Rate Sensor.
This product enables training in a group without interference from other heart
rate sensors.