Installation Guide

F o r Mode l s : 78-1 36, 87-136

Tools

Maintenance

Your new bathtub faucet is designed for years of trouble-free performance.

Keep it looking new by cleaning it periodically with a soft cloth. Avoid

abrasive cleaners, steel wool and harsh chemicals as these will dull the finish

and void your warranty.

Adjustable wrench

knife

Pipe tape

Phillips screwdriver

• If you use soldering for the installation of the faucet, the seats,

and

washers

will have to be removed before using flame. Otherwise,

warranty will be

void on these parts.

• Protect your eyes with safety glasses when cutting or soldering water

supply line.

•Cover your drain to avoid losing parts.

SatetyTips

Important Points

Prior to beginning installation, turn off the cold and hot water lines and open the old

faucet to release built-up pressure. When installing your new faucet,turn the connector

nuts finger-tight, then use one wrench to anchor the fitting and a second wrench to

tighten the nut one additional turn. Connections that are too tight will reduce the

integrity of the system. Wrap all threaded connections with Teflon tape available at

your local hardware or plumbing supply store.Always wrap in a clockwise direction.

The fittings should be installed by the State-licensed plumber.

All installations can vary depending on how your previous faucet was installed.

Necessary supplies to install your faucet are not all included; however, they are

available wherever plumbing supplies are sold. When choosing your installation

supplies, make sure they are IAPMO and/or CSA approved products.

Things You May Need

Spirit level

F OR F REE STA N D I N G T UBFI LLER F A U C E T

PAGE 1
Tools FOR FREE STANDING TUBFILLER FAUCET Adjustable wrench knife Pipe tape Phillips screwdriver Spirit level Maintenance Your new bathtub faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
PAGE 2
Shut off main water supple before installation.Then determine the depth of the embedded hole.Ensure the hole deep in between 2 12/25” to 5 11/14”. ΦΦFinish floor ΦΦFinish floor min 2 12/25“ 1 2 max 5 11/14“ Prep ar at ion / As semb l y 2-<3/4”-14NPT> 5 3/10” Put the embedded part into the hole,draw the location of the mounting holes.Make sure that the level of location of embedded with spirit level .
PAGE 3
P repar at ion/Ass emb l y 4 Cut the plastic shield so that it extends 3/8" above the surface of the finished floor. 5 Loosen the lock screws，set aside. Then remove the sealing test plug. 5-1 5-2 6 Get the faucet from the packing and push up the escutcheon.Connecting the faucet with the embedded part .Then adjust the direction of faucet and tighten the screws using an 6 mm Allen wrench.
PAGE 4
Prepara t ion /Ass emb l y 7 Seal the floor around the plastic shield with waterproof sealant,push down the escutcheon to the floor. 7-2 7-1 8 Connect the hose and the hand shower ,then rest the hand shower in the holder.Turn on on-off valve to test the situation of water.