Installation Guide

Preparation/Assembly
6
4
Steps 4-6
5
Cut the plastic shield so that it extends 3/8" above the
surface of the finished floor.
Loosen the lock screws，set aside. Then remove the sealing test plug.
5-1
5-2
6-2
6-3
6-4
Get the faucet from the packing and push up the escutcheon.Connecting
the faucet with the embedded part .Then adjust the direction of faucet
and tighten the screws using an 6 mm Allen wrench.
6-1
Make sure the slot side be directed at arrow when you install the faucet