User's Manual

LAUNCH CRP-HD User's Manual
17
Fig. 5-20
To select certain data stream item, just tap
, then the selected item will
be activated and will change into .
To select all items of the current screen, tap
, and then tap “OK” to enter
data stream reading interface. See Fig. 5-21.
To deselect all items, tap
.
Fig. 5-21
: Tap it to select all data stream items.
After selecting, tap
, the system will display data changes in waveform.
To start to record, tap
; To stop recording, tap .
On data stream reading page, the following operations can be done:
: Tap to select the desired data stream to be browsed, and then tap it to
view the waveform.
: Tap to start recording diagnostic data for future playback and view.
The saved file follows the naming rule: It begins with vehicle type, and
then the record starting time and ends with .x431 (To differentiate between
les, please congure the accurate system time). For details on playback
operations, please refer to Chapter 5.6 “My Data”.
: To save the current data in text format.
Tap
to return to the function selection screen.
5.6 My Data
This option is used to view the diagnostic report generated in process of
vehicle diagnosis. Additionally, delete, send operations are also supported.
Tap “My Data” to enter the report review screen:
If user records the running parameters while reading data stream, .x431
le will be shown under “Diagnosis playback” tab.
In case the DTC result is saved as .txt le on Read Trouble Code page, .txt
le will be displayed under “Report” tab.
Tap certain diagnostic report (.txt) to view it.