User's Manual

Launch Tech Co., Ltd.
2. Technical Parameters
 Working voltage: DC 9 -18V
 Average working current: About 35mA
 Standby current: About 25mA
 Working temperature: -10 to 50℃
 Storage temperature: -30 to 70℃
 Storage humidity: <80%
 Working humidity: <60%
3. Connections
3.1 Preparation

Turn on the vehicle power supply.

Throttle should be closed at its close position.
3.2 DLC location
The DLC (Data Link Connector or Diagnostic Link Connector) is typically a standard 16 pin connector
where diagnostic code readers interface with the vehicle’s on-board computer. The DLC is usually
located 12 inches from the center of the instrument panel (dash), under or around the driver’s side for
most vehicles. If Data Link Connector is not located under dashboard, a label should be there telling
location. For some Asian and European vehicles, the DLC is located behind the ashtray and the ashtray
must be removed to access the connector. If the DLC cannot be found, refer to the vehicle’s service
manual for the location.
Fig. 3-1
3.3 Vehicle connection
The method used to connect the diagnostic connector to a vehicle’s DLC depends on the vehicle’s
configuration as follows:

A vehicle equipped with an OBD II management system supplies both communication and 12V power