User's Manual

32
MAXIMUS2.0 User's Manual
7.4.2 Inside the vehicle test
Battery test and charging system & actuation system test can be done
in this mode.
1. Battery test
Enter battery test main menu, and select a desired test environment
as shown in Fig. 7-4.
Fig. 7-4
Notes: The sequences of inside the vehicle and outside the vehicle
test are almost the same, but under inside the vehicle condition, all
loads in vehicles must be powered off for getting an exact test value.
Firstly, the system detects whether fl oating electricity exists or not 1.
before testing. If yes, turn on the headlamp to remove it. Otherwise,
the system starts test program directly.
Tap [Inside the vehicle], the system starts detecting floating 2.
electricity automatically. If floating electricity is detected, it will
prompt you to turn on the headlamp.
Follow the on-screen instructions to turn on headlamp, the system 3.
starts removing fl oating electricity.
Once the fl oating electricity is removed, a prompt message box “The 4.
fl oating electricity has been removed, please turn off the headlamp
to continue the testing” will appear on the screen.
Follow the on-screen instructions to turn off the headlamp and 5.
tap [OK], the system will continue the testing. Tap
, it will enter
testing standard selection screen. See Fig. 7-5.
Fig. 7-5
Select a testing standard except for JIS and tap 6.
, a screen
similar to Fig. 7-6 will appear. Users can adjust capacity size by
tapping on < or > or by dragging the slider on the bar.
Fig. 7-6