User Manual

LAUNCH X-431 V+ V4.0 User Manual
87
10 Videoscope
10.1 Introduction
The videoscope function is a software application that applies to invisible parts
of an engine, such as fuel tank, braking system. With the help of an automotive
videoscope (purchased separately), you can testify the existence of internal
carbon deposit and damage inside the engine freely.
The videoscope is mainly consisted of an inspection camera, a flexible tube and
a data cable. The water-resistant camera lens with adjustable LED lights can
increase visibility to areas that cannot be seen in wet, dark, fluid soaked places,
while the flexible tube stretches your access to hard-to-reach areas.
In addition, the captured pictures and videos also provide you intuitive data for
easy analysis.
10.2 Connections & Operations
To perform a videoscope inspection:
1. Insert the data cable of the videoscope into the charging/data I/O port of port
of the tablet.
2. Bend the neck of the flexible tube as desired and extend the camera with
adjustable LED lights to some unseen or unreachable parts of engine,
hydraulic system, nozzles etc.
3. After connections are properly made and turn the tablet on. Go to Others ->
Videoscope to run it, then the screen will display the scene captured from the
videoscope camera.
5. Adjust it until the lens stops in the desired place and then use the dial for LED
light brightness to adjust the brightness.
6. Press the Snapshot button on the videoscope to take a photo. Alternatively,
you can also press the Snapshot button on the tablet to take photos.
To record a video, switch from Camera mode to Video mode and tap the
Record button on the screen to start recording.
Images are captured in .jpg format and videos are recorded in .avi or .mp4
format. All photographings and videos are saved in DCIM folder where users
can browse and replay it.