User Manual
Table Of Contents
- Copyright Information
- Trademark Information
- Precautions on using the tool
- Precautions on operating vehicle’s ECU
- 1 Introductions
- 2 Preparations
- 3 Network Setup
- 4 How To Diagnose
- 5 Special (Reset) Function
- 5.1 Oil Reset Service
- 5.2 Electronic Parking Brake Reset
- 5.3 Steering Angle Calibration
- 5.4 ABS Bleeding
- 5.5 Tire Pressure Monitor System Reset
- 5.6 Gear Learning
- 5.7 IMMO Service
- 5.8 Injector Coding
- 5.9 Battery Maintenance System Reset
- 5.10 Diesel Particulate Filter (DPF) Regeneration
- 5.11 Electronic Throttle Position Reset
- 6 Remote Diagnosis
- 7 Software Update
- 8 Maintenance Help
- 9 Personal Center
- 10 Others
- 11 FAQ
LAUNCH X-431 PROS MINI V3.0 User Manual
10
3 Network Setup
*Note: If you don’t need to use WLAN for a while, you can turn it off to conserve
battery life.
The tablet has built-in WLAN module that can be used to get online. Once you’re
online, you can register your tool, surf the Internet, get apps, send email, launch
the remote diagnosis, and check for software updates etc.
3.1 Connect to a WLAN network
1. On the home screen, tap
Settings -> WLAN
.
2. Slide the WLAN switch to ON, the tablet starts searching for available
wireless networks.
3. Select a wireless network,
If the chosen network is open, the tablet will connect automatically;
If the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, it indicates the connection is complete.
*Note: When WLAN is not required, this should be disabled to conserve battery power.
Once it is connected successfully, tap the WLAN network from the list to view its
name, link speed, security type, IP address etc.
When this tool is in range, it will connect to the previously linked network
automatically.
3.2 Disconnect from a WLAN network
1. On the home screen, tap
Settings -> WLAN
.
2. Tap the network with a
Connected
status, then tap “Disconnect”.