User Manual
Table Of Contents
- Copyright Information
- Trademark Information
- Precautions on using the tool
- Precautions on operating vehicle’s ECU
- 1 Introductions
- 2 Preparations
- 3 Network Setup
- 4 How To Diagnose
- 5 Special (Reset) Function
- 5.1 Oil Reset Service
- 5.2 Electronic Parking Brake Reset
- 5.3 Steering Angle Calibration
- 5.4 ABS Bleeding
- 5.5 Tire Pressure Monitor System Reset
- 5.6 Gear Learning
- 5.7 IMMO Service
- 5.8 Injector Coding
- 5.9 Battery Maintenance System Reset
- 5.10 Diesel Particulate Filter (DPF) Regeneration
- 5.11 Electronic Throttle Position Reset
- 6 Remote Diagnosis
- 7 Software Update
- 8 Maintenance Help
- 9 Personal Center
- 10 Others
- 11 FAQ
LAUNCH X-431 PROS MINI V3.0 User Manual
28
performing this function, please be sure the vehicle’s ignition key is in the ON
position with the engine off.
In Fig. 4-21, tap “Clear Fault Code”, a confirmation dialog box pops up on the
screen. Tap “Yes” and the system will automatically delete the currently existing
trouble code.
*Note: The trouble code will not disappear until the trouble was completely cleared.
D. Read Data Stream
This option lets you view and capture (record) real-time Live Data. This data
including current operating status for parameters and/or sensor information can
provide insight on overall vehicle performance. It can also be used to guide
vehicle repair.
*Notes: If you must drive the vehicle in order to perform a troubleshooting procedure,
ALWAYS have a second person help you. Trying to drive and operate the diagnostic
tool at the same time is dangerous, and could cause a serious traffic accident.
In Fig. 4-21, tap “Read Data Stream”, the system will display data stream items.