User Manual

LAUNCH
CReader Series English User’s Manual
31
7. The Register Code shown in figure 7-5 is the Register Code needed in step 3.
(Return to step 3 and input the Register Code and then proceed)
8. Install the memory card from the tool into the supplied memory card adaptor
and insert into the USB port of the computer.
9. Reopen the update tool, select the updates you would like to perform or click
"Select All", and then click [Download] to start downloading.
10. Once all steps are complete, reinsert the memory card into the tool and power
the tool via USB cable or via OBD II cable. A dialog box (Note: If only
diagnostic software is updated and no firmware package is downloaded, this
box will not appear) prompting you to update will pop up on the screen (See
figure 7-6), select [OK].
Figure 7-6
11. The registration process is complete, your tool is now ready for use.
Method 2: Via USB Cable
Note: Make sure the computer has an Internet connection.
1. Connect one end of the USB cable to the USB port of computer, and the other
end to the tool.
2. If a newer version is found, a screen similar to figure 7-7 appears.