Manualshelf

User Manual

ManualsBrandsLAUNCH ManualsAutomotiveOBD2 Scanner CRP123X Code Reader, 2021 Newest Launch Scanner for ABS SRS Engine Transmission Scan Tool, Android 7.0, 5.0’’Touchscreen, Auto VIN One-Click Wi-Fi Free Update Car Diagnostic Tool
12345678910
iii
LAUNCH Professional 123X User Manual
EN
• Use extreme caution when working around the ignition coil, distributor cap,
ignition wires and spark plugs. These components create hazardous voltages
when the engine is running.
• Put the transmission in P (for A/T) or N (for M/T) and make sure the parking
brake is engaged.
• Keep a re extinguisher suitable for gasoline/chemical/ electrical res nearby.
• Don’t connect or disconnect any test equipment while the ignition is on or the
engine is running.
• Keep this tool dry, clean, free from oil/water or grease. Use a mild detergent
on a clean cloth to clean the outside of the tool, when necessary.
• Please use the DC 5V power adaptor to charge this tool. No responsibility
can be assumed for any damage or loss caused as a result of using power
adaptors other than the right one.
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This device has been evaluated to meet general RF exposure requirement. The
SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device
types Professional Diagnostic Tool with model Creader Professional 123X has
also been tested against this SAR limit. The highest reported SAR values for
body-worn is 1.19 W/kg. This device was tested for typical body-worn operations
with the back of the handset kept 0mm from the body. The use of accessories
that do not satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
Hereby, Launch Tech Co., Ltd declares that the Creader Professional 123X of
Professional Diagnostic Tool is in compliance with Directive 201/53/EU.
The full text of the EU declaration of conformity is available at the following
internet address: http://www.cnlaunch.com/
Operation Frequency: WiFi 802.11b/g/n HT20:2412-2472MHz;
802.11n HT40:2422-2462MHz
Max. RF Output power: Wi(2.4G): 19.88dBm
The RF frequencies can be used in Europe without restriction.