User's Manual

LAUNCHLAUNCH
22 23
www.x431.com [phone] www.x431.com [phone]
4.2 Main Menu
4.2.1 Function modules
The main menu screen includes the following function modules:
Figure 4-1
Modules Descriptions
TPMS
This function allows you to perform the TPMS sensor
activation, programming and relearning functions.
OBD
This option presents a quick way to check for DTCs,
isolate the cause of the illuminated Malfunction Indicator
Lamp (MIL), check monitor status prior to emissions
certication testing, verify repairs, and perform a number
of other services that are emission-related.
SETUP
Displays the tool setup menu, which lets you make
several adjustments and settings to congure the tool to
your particular needs.
HELP
Helps you have a general knowledge of the DLC location,
tool information etc.
4.2.2 Icons & Symbols
The table below lists some possible on-screen icons and symbols and the
denitions.
4. Initial Use
4.1 Charging & Turning On/O󰀨
4.1.1 Charging
There are three methods available for charging the tool.
1. Via AC outlet
Connect one end of the charging cable to the charging port of the tool, and
other end to the power adaptor. Plug the power adaptor into a AC outlet to
start charging.
When charging is finished the charging complete symbol
replaces the
charging symbol. Unplug the power adaptor from the AC outlet and disconnect
the charging cable from the tool.
2. Via Computer
Connect one end of the charging cable to the charging port of the tool, and
other end to a USB port on the computer to start charging.
When charging is finished the charging complete symbol
replaces
the charging symbol. Disconnect the charging cable from the tool and the
computer.
3. Via OBD Diagnostic Port (Not recommended)
If the tool is properly connected to the vehicle’s DLC(Data Link Connector)
port, it will be charged automatically.
Note: Attempting to charge the tool via OBD diagnostic port will consume
vehicle’s baery power. You are not recommended to charge the tool in this way
except for OBD diagnosis operaons.
4.1.2 Turning On/O󰀨
Press for about 3 seconds to turn it on.
Press
for about 8 seconds to turn it o󰀨.