User Manual

LAUNCH

CReader Series English User’s Manual

function must be performed so that the immobilizer control system on the car

identifies and authorizes remote control keys to normally use the car.

When the ignition switch key, ignition switch, combined instrument panel, ECU,

BCM, or remote control battery is replaced, anti-theft key matching must be

performed.

5.3.10 Injector Coding (Only applies to CReader 9081)

Write injector actual code or rewrite code in the ECU to the injector code of the

corresponding cylinder so as to more accurately control or correct cylinder

injection quantity.

After the ECU or injector is replaced, injector code of each cylinder must be

confirmed or re-coded so that the cylinder can better identify injectors to

accurately control fuel injection.

5.3.11 Electronic Throttle Position Reset (Only applies to CReader 9081)

This function enables you to make initial settings to throttle actuators and returns

the “learned” values stored on ECU to the default state. Doing so can accurately

control the actions of regulating throttle (or idle engine) to adjust the amount of air

intake.

5.4 Review

This function is used to review or delete the recorded DTC, Data Streams and

Freeze Frame.