User Manual
iii
LAUNCH 
 TOUCH PRO ELITE User Manual
•  Keep this tool dry, clean, free from oil/water or grease. Use a mild detergent 
on a clean cloth to clean the outside of the tool, when necessary.
•  Please use the 5 V DC power adaptor to charge this tool. No responsibility 
can be assumed for any damage or loss caused as a result of using power 
adaptors other than the right one.
FCC Statement:
Any Changes or modications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.
This device  complies with part  15 of the FCC  Rules. Operation is  subject to the following 
two conditions: (1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired operation.
Note: This  equipment  has been tested and  found  to  comply  with the limits for  a 
Class B digital device, pursuant to Part  15 of the  FCC Rules. These limits  are designed 
to provide reasonable protection against harmful interference in a residential installation. 
This  equipment  generates,  uses,  and  can radiate  radio  frequency  energy,  and  if  not 
installed and  used  in  accordance with the instructions, may  cause  harmful interference 
to radio communications. However, there is no guarantee that interference will not occur 
in a particular installation.  If this equipment does cause  harmful interference to radio or 
television reception, which can be determined by turning the equipment o and on, the user 
is encouraged to try to correct the interference by one or more of the following measures:
-  Reorient or relocate the receiving antenna.
-  Increase the separation between the equipment and receiver.
-  Connect the equipment into  an  outlet  on  a  circuit different from  that  to  which the 
receiver is connected.
-  Consult the dealer or an experienced radio/TV technician for help.
TOUCH PRO  ELITE  (FCC  ID:  XUJPROELITE)  has  been  evaluated  to  meet  general  RF 
exposure requirement. The highest reported SAR value is 0.58W/kg. This device was tested 
for typical body-worn operations with the back  of  the  handset  kept  0mm  from  the  body. 
The use of accessories that do not satisfy these requirements may not comply with FCC RF 
exposure requirements, and should be avoided. 
Hereby, Launch Tech Co., Ltd. declares that this Professional Diagnostic Tool (Model TOUCH 
PRO ELITE) is in compliance with the essential Requirements and other relevant provisions 
of Radio Equipment Directive 2014/53/EU.
Operation frequency and Max. RF output power: 
WiFi 802.11b/g/n(2.4G): 2412-2472MHz, 18.92dBm; 
The RF frequencies can be used in Europe without restriction.










