User Guide

LAUNCH X-431 V User Manual — General Operations

2 Preparations

2.1 Charging X-431 V

There are two charging methods available:

Via Power adaptor:

1. Insert one end of the included USB cable into the power adaptor.

2. Connect the other end into the charging port of X-431 V.

3. Plug the adaptor into AC outlet.

Via PC:

1. Insert one end of the included USB cable into the USB port of PC.

2. Connect the other end into the charging port of X-431 V.

appears on the screen, it indicates it is being charged. If the logo changes

into

, it indicates that the battery is fully charged. Unplug the USB cable on the

charger from X-431 V.

2.2 Using your battery

 If the battery remains unused for a long period of time or the battery is

completely discharged, it is normal that the tool will not power on while being

charged. Please charge it for a period of 5 minutes and then turn it on.

 Please use the included power adaptor to charge your tool. No responsibility

can be assumed for any damage or loss caused as a result of using power

adaptors other than the one supplied.

 While X-431 V has low battery, a beep will sound. If it is very low, X-431 V will

be switched off automatically.

2.3 Power on/off

2.3.1 Power on

Press [POWER] to turn the tool on.

Note: If it is the first time you have used this tool or the tool remains idle for a long

period of time, the tool could fail to turn on. Please charge the tool for a minimum of 5

minutes and attempt to turn on again.

2.3.2 Power off

Press [POWER] for 3 seconds, an option menu will pop up on the screen. Tap

“Power off” to turn the tool off.