User's Manual

Warranty
The sensor is guaranteed to be free from material
and manufacturing defects for a period of twenty-four
(24) months or for 31000 miles, whichever comes
first. This warranty covers any defects in materials or
workmanship under normal use during the warranty
period. Excluded from the warranty are defects due
to improper installation and usage, induction of
defect by other products, damage due to collision or
tire failure.
5. Remounting the tire
Place the tire on the rim, ensure that the valve starts
on the opposite side of the rim from the tire fitting
head. Mount the tire over the rim.
Caution: Strictly follow tire changer manufacturer ’s
instructions to mount the tire.
Caution: Make sure that the nut and cap are installed
on the outside of the rim.
3. Dismounting the sensor
Remove the cap and nut from
the valve stem, and then
remove the sensor assembly
from the wheel rim.
4. Mounting the sensor and valve
Step 1. Remove the cap and
nut from the valve stem.
Step 2. Place the valve stem through the valve hole of
the rim, ensuring the sensor body located on the
inside of the rim. Assemble the nut back on the valve
stem with a torque of 4N·m, then tighten the cap.
T
W
C
-
4
1
1
N
I
C
Caution: The bead loosener must be facing the
valve.
Installation Steps
Remove the valve cap and nut and deflate the tire.
Use the bead loosener to break the tire bead.
1. Loosening the tire
2. Dismounting the tire
Clamp the tire on the tire
changer, and adjust the valve
at 1 o’clock to the tire fitting
head. Use the tire tool to
dismount the tire bead.
Caution: Always observe
this starting point during the
whole dismounting process.
Sensor body
Washer & nut
Valve stem
Rubber grommet
and valve core
assembly
Screw
Cap
Technical Parameters
Weight <30g
Dimension(L*W*H) About 72*51*27mm
Working Frequency 433MHz/315MHz
Working Voltage 3V
IP Rating IP67
Components Controls&
When replacing or servicing the sensor, please only
use the original valves and accessories provided by
LAUNCH to ensure proper sealing. It is mandatory to
replace the sensor if it is externally damage. Always
remember to tighten the nut to the correct torque of 4N·m.