User Manual

LAUNCH X-431 PAD V User Manual
11
3 Initial Setup
3.1 Charging the Tablet
*Notes:
•
Only use the included power adaptor to recharge the tablet. Use of any other
adaptor will damage the tool. We assume no responsibility for damage or loss
resulting from using other similar adaptors other than the specified one.
•
Always charge on a non-flammable surface in a well-ventilated area.
To check the battery power level, press and hold the Power button about 3
seconds to turn on the tablet. Power level is indicated as a percentage in the
upper right corner of the screen. If the power level drops below 10% while the
tablet is on, a “Connect Charger” notification will appear on the screen.
3.1.1 Charging with the included 5V power adaptor
1. Connect one end of the power adaptor to charging port of the tablet, and the
other end to the AC outlet.
2. The charging LED illuminates solid red and the charging symbol
will
appear on the screen.
3. Once it illuminates solid green, it indicates that the battery is fully charged
and the charging complete symbol
replaces the charging symbol.
Disconnect the power adaptor from the AC outlet.
3.1.2 Charging with the docking station
1. Locate the charging slot on the bottom of the tablet and docking station.
2. Align the charging slots, and then dock the tablet into the station to ensure
that it is firmly seated on the docking station.
3. Insert one end of the included power cord to the charging port of the docking
station, then the other end into the AC outlet. The charging LED illuminates
solid red while charging and the charging symbol
will appear on the
screen.
4. Once it illuminates solid green, it indicates that the battery is fully charged