Dimensions Guide

TLT 210-XT
Features & Benets
5
3
Specications
A. Maximum Lifting Height
B. Minimum Column Height
C. Cylinder Full Height
D. Total width
E. Drive-Thru Clearance
F. Floor to Overhead Switch
G. Front Arm Reach (min / max)
H. Rear Arm Reach (min / max)
I. Screw Pad Height
J. Inside Column Width
Motor
Voltage
Rise Speed
Max. Load Per Arm
Min. Ceiling Height Required
Narrow Bay Setting
Maximum Column Height
Capacity
TLT210-XT TLT210-XT
Standard Rotated
76.4" (1940mm)
143"(3634mm)
145.2" (3688mm)
136.6" (3470mm)
98.4" (2500mm)
140" (3556mm)
23.6" (600mm) / 43.5" (1105mm)
38.6" (980mm) / 61.8" (1570mm)
4" (101mm) to 7.5" (190mm)
110.2" (2800mm)
2 HP
208-230 Volt/60hz./Single Phase
54 Seconds
2500 lbs (1134 Kilos)
143.5" (3644mm)
Deduct 5.9" (149mm)
149" (3874mm)
10,000 lbs
76.4" (1940mm)
143"(3634mm)
145.2" (3688mm)
137.9" (3502mm)
92" (2338mm)
140" (3556mm)
23.6" (600mm) / 43.5" (1105mm)
38.6" (980mm) / 61.8" (1570mm)
4" (101mm) to 7.5" (190mm)
101.9" (2588mm)
2 HP
208-230 Volt/60hz./Single Phase
54 Seconds
2500 lbs (1134 Kilos)
143.5" (3644mm)
Deduct 5.9" (149mm)
149" (3874mm)
10,000 lbs
Double Telescoping Screw Pads - Used with or without rubber pads
oering 6.5” adjustment for complete vehicle coverage.
Standard Asymmetric - Lift installed with columns facing each other.
Rotated Asymmetric - Lift installed with columns offset - rotated.
Outer Hose Guards - Protects hydraulic hoses from damage.
Adjustable Column Height - Provides an extra 6” of height adjustment for ease
of installation with various ceiling heights.
Adjustable Column Width - Provides extra 6” of width adjustment for
narrow service bays to custom fit your shop.
Single Point Lock Release - Allows technicians to disengage both column
locks simultaneously.
Rubber Door Guards - Provides added security against door damage.
1
2
6 7
4
3
4
1
2
5
6
8
Heavy-Duty Arm Restraint System - Oversize rugged steel gears, pins,
and springs for trouble free operation.
7
10
9
8
A Word About Lift Certification: When found on an
Automotive Lift such as the product represented
by Launch Tech USA, this mark indicates that The
Automotive Lift Institute (ALI) certifies that the
TLT210-XT described herein complies with the
applicable provisions of the
American National Standards
ANSI/ALI ALCTV 2006
and is Third Party Validated
by the ETL Testing Laboratory.
9
10
Available in red
Ship Weight
1,750 lbs
1,750 lbs
Ship Dimensions
110"L x 24"W X 48"H
110"L x 24"W X 48"H
Stackable Foot Pad Extensions - Extra tall applications are no problem with
the four 6” tall and four 3” short extensions.