Installation Guide

TLT240SC Two-post User’
s Manual
5
Note:
 Before operation, the safety locking devices
must be inspected. 1) The gear blocks of the
arm end must engage the gear block of the
restraint shaft. 2) No broken strand in the
steel cable. 3) No deformation in the arm pad.
 When lifting the vehicle, all the swing arms
must be used.
 Before lifting the vehicle, check all the
hydraulic hose and fittings for oil leakage. In
case of leakage, please don’t use the lift.
Remove the fitting with leakage and re-seal.
Re-install the fitting and check if oil leakage
still exists.
 After the vehicle is lifted, when adding or
removing any major heavy object, use jack
stand to maintain the balance of the vehicle.
3.5 Lowering the Vehicle
 Clean the work area before lowering the vehicle.
 First press the start button to raise the vehicle a little,
and then pull two steel ropes on two carriages to
disengage the safety lock.
 Press the lowering handle to lower the vehicle.
 Lower the vehicle till the swing arm down to the
bottom and the lifting pads leave the vehicle chassis,
and then release the lowering handle.
 The swing arms under the vehicle must be fully
shrunk
Note: When the lift doesn’t work, you must
switch off the power.