Installation Guide

TLT240SC Two-post User’
s Manual
12
10.2.2 Base plate layout
TLT240SC symmetric installation is shown in Fig. 9 ：
 With total width (A) as the basis, draw two parallel
lines (#1 and #2) on the concrete slab, with the error
within 3mm.
 Determine the power side column location on any
chalk line, and mark the total width (B) of the base
plate. Mark the points 3 and 4.
 Starting from point 3, draw one diagonal line (C),
forming a triangle. In this way, the vertical lines can
determine the location of the two columns.
Fig.9
TLT240SC asymmetric installation is shown in Fig.10 ：
 With total width (A) as the basis, draw two parallel
lines (#1 and #2) on the concrete slab, with the error
within 3mm.
 Determine a point B at any point on chalk line #1,
based on point B, move down 131mm, then move
right 228mm to get point C. Based on point B, draw
#1’s vertical line M with a length of A to get point
D .Based on point C, draw line M’s parallel line N with
a length of L to get point E. With four points B,C,D,E,
each post’s position can be decided.
TLT240SC:3563mm(140.28in)
TLT240SC:3107mm(122.32in)
228mm(8.98in)
1
3
1
m
m
(
5
.
1
6
i
n
)
228mm(8.98in)
1＃
2＃
B
C
E
D
M
N
L
Fig.10