Installation Guide

TLT240SC Two-post User’
s Manual
14
anchor bolt .The distance from the bolt head to the
concrete floor should be more than twice of the bolt
diameter.
 Remove the dust from the hole.
 Gently tap the bolt into the hole till the washer rests
against the base plate of column.
 Fasten bolts
10.2.4 Install the top beam
ASYMMETRIC PULLEY INSTALLATION
Use the 4 pulleys (sheaves) located in the parts packaging combined with the parts in the packet marked “Asymmetric
Installation” to install the pulleys for an Asymmetric configuration. Below is what is contained in the asymmetric parts
packet.
No. Name and Specs Part Number Qty. picture
1
Asymmetric axle 103200966
4
2
Bushing Ⅱ
103203325
2
3
Bushing Ⅰ 103203324
2
4
Returning ring 25 103050035
8
Asymmetric Pulley Configurations Continued…
The photo below illustrated the proper alignment and placement of the pulleys into the overhead beam. Note the outer pulley
is positioned on the overhead beam in the outer most axle holes and that it is closest to the front of the lift. The inner pulley is
positioned in the inner most axles holes and is mounted toward the rearward area of the lift .when installing the opposite set
of pulleys they must correspond exactly as the first set of pulleys that you installed.