Product Manual

INSTALLATION INSTRUCTIONS

When the lift arrives on site:



Read the owner’s manual and make sure the installation instructions are

fully understood.



Check for any freight damages.

The shipment should be thoroughly

inspected as soon as it is received. The signed bill of lading is

acknowledgement by the carrier of receipt in good condition of shipment

covered by our invoice .If any of the goods called for on your bill of lading

are shorted or damaged, do not accept them until the carrier makes a

notation on the freight bill of the missing or damaged goods. Do this for

your own protection. Check the contents of the accessory and hardware

boxes to make sure no parts are missing.

NOTE:

IT IS DIFFICULT TO COLLECT FOR LOSS OR DAMAGE AFTER

YOU HAVE GIVEN THE CARRIER A CLEAR RECEIPT. THE LIFT

MANUFACTURER IS NOT RESPONSIBLE FOR ANY FREIGHT DAMAGE.

UNPACKING PROCEDURE

Important! Place the main structural components on wooden blocks so

that the steel shipping frames can be removed.

Remove Power Unit Box.

Remove the plastic wrapping.

Remove the cross member, and the actuator bar.

Remove the arms and parts boxes

Unbolt the steel shipping frames.

Lay each tower on the floor with the carriage side up.

Check the installation area for obstructions. (Lights, Heating Ducts,

Ceiling, Floor Drains, etc.)