Product Manual

CONNECTING THE POWER SUPPLY

1) A

certified electrician

must connect the 230Volt/1Ph power unit and

the overhead Shutoff Switch to the electrical supply.

2) Remove the sealed cover on the electrical junction box on the power

unit and connect the wiring according to the wiring diagram. See

Figure 9

3) A power supply switch is required to be installed near the lift for

rapidly disconnecting the electrical power supply during maintenance

or in case of emergency.

Figure 9

Note: Motor damage due to improper wiring is not warranted. Verify if the oil

tank is full; do not operate if there is no oil. After pressing the up button, if

the power unit does not run or makes unusual noises or has excessive heat

stop the power unit immediately and check of proper electrical connections.